Highpoint RocketRAID 1720 Guide de l'utilisateur télécharger pdf (Page 28)

RocketRAID 1720 Driver and Software Installation

4 -

2. In the popup window, select Hardware tab and then click Device Manager

button.

Double click the “SCSI and RAID controllers” entry. If the RocketRAID 1720 device

entry is not displayed, or there are “?” or “!” marks displayed near the RocketRAID

1720 entry, the driver has not been installed properly. Delete the entries and reinstall

the driver.

1 - Installing the RAID Management Console/ Interface

Overview

To install the RAID software, locate the setup.exe file located on the floppy diskette

labeled “DISK 1” (or the Disk1 folder, if the software was downloaded). Double click

this file to start the Installation Wizard.

There is no need to restart the system after installing the software. To start the

software, click on the “Start” button, select “Programs”, and click on the “HPT

Management Console.”

Logging On

The RAID Management Console requires that a user (or Administrator) log on. The

software is incapable of working with RAID arrays or hard disks attached to the

RocketRAID 1720 until the user has logged on.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 70 71

Pas de commentaire

Highpoint RocketRAID 1720 Guide de l'utilisateur Page 28