Highpoint RocketRAID 2210 Guide de l'utilisateur télécharger pdf (Page 58)

Linux Driver Support

5-8

#ln –sf /etc/init.d/hptdriver /etc/rc.d/rc4.d/S01hptdriver

#ln –sf /etc/init.d/hptdriver /etc/rc.d/rc5.d/S01hptdriver

Step 4 Configure System to Mount Volumes during Startup

The system can be instructed to automatically mount the array(s) during startup by

modifying the file”/etc/fstab”.

For example, add the following line to tell the system to mount /dev/sda1 to location /

mnt/raid after startup:

/dev/sda1 /mnt/raid ext2 defaults 0 0

3 - Updating the Driver

If you are not booting from disks attached to RocketRAID 2210 controller, you can

update the driver just by reinstalling it following the procedure outlined in the

previous section, “Installing the RocketRAID 2210 driver for an Existing System”.

If you are running the system installed to a disk or array attached to the RocketRAID

2210:

First, obtain the new driver module “rr2210.ko”. Refer to the previous section

“Obtain the Driver Module”. In following steps, we assume it has been copied to

“/tmp/rr2210.ko”.

Replace rr2210.o in the boot RAM disk image, /boot/initrd-xxx.img (where xxx is

the kernel version).

Example: (2.4.21-4.EL for Red Hat Enterprise Linux 3.0):

# gzip -dc /boot/initrd-xxx.img > /tmp/initrd.ext2

# mkdir /mnt/initrd

# mount -o loop /tmp/initrd.ext2 /mnt/initrd

# cp /tmp/rr2210.o /mnt/initrd/lib/rr2210.o

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 98 99

Pas de commentaire

Highpoint RocketRAID 2210 Guide de l'utilisateur Page 58