Highpoint ROCKETRAID 2314 Guide de l'utilisateur télécharger pdf (Page 60)

Linux Driver Support

For example, add the following line to tell the system to mount /dev/sda1 to location /

mnt/raid after startup:

/dev/sda1 /mnt/raid ext2 defaults 0 0

4 - Updating the Driver

If you are not booting from disks attached to RocketRAID host adapter, you can

update the driver just by reinstalling it following the procedure outlined in the

previous section, “Installing the RocketRAID driver for an Existing System”.

If you are running the system installed to a disk or array attached to the RocketRAID

host adapter:

First, obtain the new driver module “rr2310_00.ko”. Refer to the previous section

“Obtain the Driver Module”. In following steps, we assume it has been

copied to “/tmp/rr2310_00.ko”.

Replace rr2310_00.ko in the boot RAM disk image, /boot/initrd-xxx.img (where xxx

is the kernel version).

Example:

# gzip -dc /boot/initrd-xxx.img > /tmp/initrd.ext2

# mkdir /mnt/initrd

# mount -o loop /tmp/initrd.ext2 /mnt/initrd

# cp /tmp/rr2310_00.ko /mnt/initrd/lib/rr2310_00.ko

# umount /mnt/initrd

# gzip -c /tmp/initrd.ext2 > /boot/initrd-xxx.img

If you are using lilo to boot the system, use “lilo” to reinstall the RAM disk:

# lilo

Update rr2310_00.ko in /lib/modules:

# cp /tmp/rr2310_00.ko /lib/modules/‘uname –r‘/kernel/drivers/scsi/

rr2310_00.ko

Reboot your system to allow the new driver take effect.

5-8

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 91 92

Pas de commentaire

Highpoint ROCKETRAID 2314 Guide de l'utilisateur Page 60