Highpoint RocketRAID 2640x4 Guide de l'utilisateur télécharger pdf (Page 53)

Linux(Fedora,Red Hat,SuSE) Driver Support

Step 3 Configure System to Automatically Load the Driver

Most likely, you will not want to type in “insmod rr26xx.ko” each time you boot up

the system. Therefore you must install the module and tell the system about it. To

install the module, type in the following commands (first change directory to where

the proper rr26xx.ko locates):

# cp rr26xx.ko /lib/modules/‘uname –r‘/kernel/drivers/scsi

# depmod

Then you should inform the system load the module when system boots

up with the following command:

# cp rr26xx.ko /lib/modules/‘uname –r‘/kernel/drivers/scsi

# depmod

# ln –sf /etc/init.d/hptdriver /etc/rc.d/rc3.d/S01hptdriver

# ln –sf /etc/init.d/hptdriver /etc/rc.d/rc4.d/S01hptdriver

# ln –sf /etc/init.d/hptdriver /etc/rc.d/rc5.d/S01hptdriver

Step 4 Configure System to Mount Volumes when Startup

Now you can inform the system to automatically mount the array by modifying the file /

etc/fstab. E.g. you can add the following line to tell the system to mount /dev/sda1 to

location /mnt/raid after startup:

/dev/sda1 /mnt/raid ext3 defaults 0

6-7

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 83 84

Pas de commentaire

Highpoint RocketRAID 2640x4 Guide de l'utilisateur Page 53