Highpoint ROCKETRAID 2310 Guide de l'utilisateur télécharger pdf (Page 52)

Linux Driver Support

#ln –sf /etc/init.d/hptdriver /etc/rc.d/rc3.d/S01hptdriver

#ln –sf /etc/init.d/hptdriver /etc/rc.d/rc4.d/S01hptdriver

#ln –sf /etc/init.d/hptdriver /etc/rc.d/rc5.d/S01hptdriver

Step 4 Configure System to Mount Volumes during Startup

The system can be instructed to automatically mount the array(s) during startup by

modifying the file”/etc/fstab”.

For example, add the following line to tell the system to mount /dev/sda1 to location /

mnt/raid after startup:

/dev/sda1 /mnt/raid ext3 defaults 0 0

4 - Updating the Driver

If the original driver is installed in the system’s initrd (Initial RAM Disk) file (when

using a system installed to RocketRAID 2310 controller, for example), the driver

module in the initrd file should be updated using the mkinitrd command (or extract

the initrd file and replace the driver module manually).

If the original driver is installed in the /lib/modules/‘uname –r‘/kernel/drivers/scsi/

directory, and loaded by the script file (Example /etc/init.d/hptdriver) during the init

process, or the configure file (Example /etc/modules.conf), please replace it with the

new driver (rr2310.o or rr2310.ko).

5 - Uninstalling the Driver

To uninstall the RocketRAID 2310 driver

Note: The driver cannot be uninstalled while the system is booted from a disk or array

attached to the RocketRAID 2310.

To uninstall the driver, remove the lines added to /etc/fstab, and remove the files

created in the /etc/init.d directory.

5-4

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 74 75

Pas de commentaire

Highpoint ROCKETRAID 2310 Guide de l'utilisateur Page 52