Highpoint ROCKETRAID 2340 Guide de l'utilisateur télécharger pdf (Page 72)

FreeBSD Driver Support

6-7

<- For FreeBSD 5.1 and later: select “6” on “Welcome to

FreeBSD” screen.

Hit [Enter] to boot immediately, or any other key for

command prompt.

Booting [kernel] in 9 seconds…

<-press SPACE key

Type ’?’ for a list of commands, ’help’ for more de-

tailed help.

ok load rr2340

/modules/rr2340.ko text=0xf571 data=0x2c8+0x254

ok autoboot

Note: If you have configured a RAID 10 using 4 disks, it will be registered to system

as device /dev/da0. You can use “/stand/sysinstall” to create partitions and disklabels

(like da0s1e) on da0. Then, create a new filesystem using “newfs /dev/da0s1e”. Now

you can mount /dev/da0s1e to somewhere to access it.

Step 3 Configure System to Automatically Load the Driver

To avoid typing in “load rr2340” each time the operating system is booted, the system

must be instructed to automatically load the module during bootup. To configure the

system to automatically install the module, type in the following commands:

# echo ’rr2340_load=”YES”’ >> /boot/defaults/loader.conf

This command will instruct the loader to load the rr2340 module together with the

kernel. After using this command, reboot the system. The rr2340 module should now

automatically load each time the operating system starts up.

Note: When using FreeBSD 4.x, type in the following command to configure the

system:

# mknod /dev/rr2340 c 200 0

Then, check to make sure the node “/dev/rr2340”, is present in the /dev directory.

1 2 ... 67 68 69 70 71 72 73 74 75 76

Pas de commentaire

Highpoint ROCKETRAID 2340 Guide de l'utilisateur Page 72