Highpoint RocketRAID 3540 Guide de l'utilisateur télécharger pdf (Page 17)

RocketRAID 3540 BIOS Utility

The RocketRAID 3540’s BIOS Utility can be accessed using the “Ctrl+H” command.

This command should be displayed automatically when the RocketRAID 3540’s BIOS

screen appears during the system’s boot up procedure.

1 - BIOS Command Overview

The RocketRAID 3540 BIOS Utility provides a wide selection of RAID related

commands. These commands are displayed towards the top of the utility’s interface.

General Navigation

Press ALT + the first letter of the each menu item (highlighted in red) to access the

corresponding menu (Alt + D will open the “Disk” menu bar). You can also press F10

to quickly browse through the various menu selections. Use the ← → arrow keys to

select the desired item, and press ENTER to open the menu. Use the ↑ ↓ arrows keys

to select the desired command from each menu, and press the ENTER key to confirm

the selected command.

There are two windows in the utility’s interface; Disk interface and Array interface.

Use the TAB key to switch between each interface.

Supervisor/User mode

The default BIOS operation mode is User mode; user can only view some information

of the controller through BIOS. If user wants to modify the setting of the RAID

controller, it must be changed to Supervisor mode:

RocketRAID 3540 BIOS Utility

3-1

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 80 81

Pas de commentaire

Highpoint RocketRAID 3540 Guide de l'utilisateur Page 17