Highpoint RocketRAID 3540 Guide de l'utilisateur télécharger pdf (Page 72)

FreeBSD Driver Support

for FreeBSD 7.0-RELEASE

ok load disk0:hptiop-6.3.ko

for FreeBSD 7.0-AMD64-RELEASE

ok load disk0:hptiop-6.3-amd64.ko

5. After the driver has been loaded, remove the floppy diskette from the floppy

drive.

6. Type in “boot” and continue the installation as normal. You can refer to FreeBSD

installation guide.

ok boot

Note: On some systems with ACPI enabled, FreeBSD may not work. You can try to

disable ACPI in system BIOS or type the command “set hint.acpi.0.dis-

abled=”1”” under boot prompt to solve the problem.

FreeBSD 7.0 and later version natively support RR3xxx/4xxx, but you still need

to load the driver manually.

For FreeBSD 4.x/5.x/6.x version: On the driver disk, there is a setup script “postinstall”

which will do this work for you. Before you reboot the system, press Alt-F4 to the

command shell and type the following commands:

# mount –o ro /dev/fd0 /mnt

# sh /mnt/postinstall

# umount /mnt

For FreeBSD 7.x version: press Alt-F4 to the command shell and type the following

commands:

# echo ‘hptiop_load=”YES”’ >>/boot/defaults/loader.conf

Then press Alt-F1 to return to the setup screen and choose [X Exit Install] to finish

setup.

7-5

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 80 81

Pas de commentaire

Highpoint RocketRAID 3540 Guide de l'utilisateur Page 72