Highpoint RocketRAID 3540 Guide de l'utilisateur télécharger pdf (Page 59)

Linux Driver Support

Step 4 Configure System to Automatically Load the Driver

Most likely, you will not want to type in “insmod hptiop” each time you boot up the

system. You can add the driver to the initial RAM disk image to load the driver at boot

time:

1. Edit file /etc/sysconfig/kernel and add hptiop module to the line

INITRD_MODULES=..., e.g:

INITRD_MODULES=”reiserfs hptiop”

2. Run depmod to update module configuration:

# depmod

3. Run mkinitrd to update the initrd file:

# mkinitrd

4. If you are using lilo boot loader, run lilo again:

# lilo

Step 5 Configure System to Mount Volumes when Startup

Now you can inform the system to automatically mount the array by modifying the file

/etc/fstab. E.g. You can add the following line to tell the system to mount /dev/sda1 to

location /mnt/raid after startup:

/dev/sda1 /mnt/raid ext2 defaults 0 0

4 - Updating the Driver

To update the driver, simply reinstall the driver following the steps in previous

section, “ Install RR3540 Driver on an Existing System “.

If the driver is loaded in initrd (e.g. when system is installed on the controller), you

need to run mkinitrd to update the initrd file. Also, if you are using lilo boot loader,

you need to run lilo again.

6-12

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 80 81

Pas de commentaire

Highpoint RocketRAID 3540 Guide de l'utilisateur Page 59