Highpoint RocketRAID 3510 Guide de l'utilisateur télécharger pdf (Page 63)

Linux Driver Support

6-10

5. Next. Select “back” to return to the installer.

6. Installation will now proceed normally. Refer to SLES Linux documents for

additional OS installation procedures.

Additional Installation Notes:

The system device mapping order is the same as the order shown in RocketRAID

host adapter’s BIOS Setting Utility. If no other SCSI adapters are installed, the device

marked as “BOOT” or “HDD0” will be identified as /dev/sda, “HDD1” as /dev/sdb,

“HDD2” as /dev/sdc, etc. When creating mount points, /boot must be mounted on /

dev/sda.

3 - Installing the RocketRAID 3xxx Driver on an Exist-

ing System

If you are currently running SLES and would like to access drives or arrays attached

to the Rocket RAID host adapter, follow the steps outlined below:

Note:

1. If a SCSI adapter is used to boot the system, make sure the RocketRAID

host adapter’s BIOS loads/posts after the SCSI adapter’s BIOS. It may be

necessary to move the adapter(s) to another PCI slot.

2. The driver may work incorrectly on certain motherboards (such as DFI77B

KT400). For these motherboards, add the “acpi=off” kernel parameter in the /

boot/grub/menu.lst:

kernel (hd0,1)/vmlinuz root=/dev/hda1 acpi=off

initrd (hd0,1)/initrd

Step 1 Update Grub

If you are running an SLES SMP System, you must first update the /boot/grub/menu.lst.

Example:

default=0

timeout=8

title Linux

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 79 80

Pas de commentaire

Highpoint RocketRAID 3510 Guide de l'utilisateur Page 63